Logo

B3546 Engine Code Repair

Meaning of B3546 engine trouble code is a kind of body trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

B3546 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting

If one of these reasons for B3546 code is occuring now you should check B3546 repair processes.
Now don't ask yourself; What should you do with B3546 code ?
The solution is here :

B3546 Possible Solution:

B3546 Engine

The firing order is an important part of the overall design of the engine and is determined during the design of the engine to eliminate as much engine vibration as possible. If the firing order is changed or adjusted, the ignition from the spark plug is delivered at the wrong time and the engine functions poorly or does not run. The firing order for a particular engine is typically found in the repair manual specific to that model.

B3546 Code Meaning :

B
OBD-II Diagnostic Body (B) Trouble Code For Engine

3
Ignition System Or Misfire

5
O2 Sensor Heater Circuit Malfunction

4
Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)

6
Crankshaft Position Sensor B Circuit Malfunction

Regarding the B3546 code, it would probably be worthwhile to carefully inspect the wire harness near the intake manifold bracket. This is done most easily from below the car in the area near the oil filter.

B3546 OBD-II Diagnostic Body (B) Trouble Code Description

B3546 engine trouble code is about Crankshaft Position Sensor B Circuit Malfunction.

Main reason For B3546 Code

The reason of B3546 OBD-II Engine Trouble Code is O2 Sensor Heater Circuit Malfunction.

B3546 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.